Spring feeding for winter oilseed rape starts with the plants that will stay in the field to produce seed. The outer leaves may have blackened over winter while the centre of the rosette and its crown remain alive. Check those first. Then compare the crop's green canopy, soil conditions and nutrients already supplied. Those observations help determine the remaining nitrogen and sulfur requirements and when machinery can reach the crop. This guide concerns a commercial seed crop grown through winter.
Start at the crown
Walk across the field and stop in several representative areas. Visit the interior, a slope, the headland and any hollows where water or ice persisted. Put the limits of damaged patches on a field map and note how evenly the live rosettes are distributed. Use autumn photos or establishment records where you have them. A gap that was already present before winter belongs in the survival assessment, but cannot be attributed to the latest frost.
Dig out a few whole plants with their taproots rather than trying to assess them only from above. Look at the junction between the root and the base of the rosette, the crown and the central growing point. Compare specimens from the worst patch with plants from a representative part of the field. Look for new growth at the centre during the return to active growth. If survival is hard to call straight after a short thaw, revisit the marked plants later or arrange for an agronomist to examine samples. Establish which area is worth keeping under rape before placing an order for the whole field.
Assess the green area that survived
Two zones with a similar plant count can look very different. One may have broad green rosettes, and the other little more than living growing points. Take a photograph vertically over the same ground area at several representative stops for comparison. A green area index, where used, expresses the green leaf and stem area relative to the ground area below. The percentage of soil hidden in a photograph is a useful comparison on repeat visits, but it is a different measure.
The amount of green growth matters to the timing discussion. A thin canopy restarting with small rosettes and a full canopy already carrying plenty of live leaf do not automatically need the same nitrogen plan. Record whether most plants are still unfolding new leaves in the rosette or the central stem is starting to extend. A date entered when the crop was sown is no substitute for this check. Keep the objective clear as the crop moves from regrowth through stem development, flowering and seed filling.
Plan nitrogen and sulfur in separate columns
For nitrogen, gather the previous crop, soil tests, autumn applications and any organic or mineral inputs already included in the plan. Ask the laboratory what forms of nitrogen its report measures and which soil layers it represents. Use the actual canopy and field's needs when interpreting the results with your agronomist. The guide to nitrogen fertilizers explains what to compare on the label. Packs with similar weights can supply quite different totals of the element.
Treat sulfur as a separate line in the calculation. Lighter soils after a wet winter can have a higher risk of shortage. That is a reason to consider field history and drainage, not a dose for every zone. Add the soil texture, earlier use of organic materials and any relevant mineral sources to the record. Check whether the field plan and product label describe sulfur as S or SO₃. Compare figures on the same basis before deciding how much remains to buy.
When younger leaves become pale, include sulfur in the investigation alongside root condition, moisture and evidence of growth. Colour alone cannot establish the cause. Compare a weak patch with a nearby healthy patch at the same stage. Give the agronomist photographs and the field's nutrient history. If tissue testing is appropriate, ask the laboratory which leaves to take and from where. Where paleness follows waterlogging, look at the soil and roots as well as the leaves.
A wet hollow and a better-drained edge
Imagine one wet hollow where there are only occasional surviving rosettes and their crowns need another look. On a lighter, better-drained edge the plants are growing again, but the newest leaves are pale after a wet winter. Start in the hollow with survival and the ground's ability to carry machinery. For the edge, add sulfur risk and nutrient history to the list before deciding what to test. The two patches may look equally pale from the road while needing different follow-up.
Decide when the soil can carry traffic
Thaw, another cold spell and soil drying can fall in a different order across Ukrainian fields. A sheltered hollow may still be too wet when the slope alongside is working. Check the actual entrance, turning areas and lanes before arranging the application. Keep waterlogged or soft areas as separate zones. If several days pass after the inspection, look again at ground conditions and the stage in the most advanced part before sending equipment out.
Take separate samples where soil or past management differs. The guide to assessing soil before choosing fertilizer explains how to describe the site. Agree sample depth and method for the field with the laboratory. Assess phosphorus and potassium with the test results and records of what was already spread. If you are considering a compound product, read the guide to phosphorus and potassium fertilizers to help compare the nutrients on the label with the actual field plan.
Prepare an order from the viable area
- Write down the area that will remain under rape. Set aside those zones where survival is still uncertain.
- Put nitrogen and sulfur requirements in separate rows and state the units used in the plan.
- Credit inputs already counted. When one fertilizer supplies both elements, enter its contributions in both rows.
- Agree the intended field operation and a weather-dependent working window. Confirm the exact product, pack size and delivery point before placing the order.
After the operation, record the area actually treated and revisit the marked observation points. Leave zones skipped because of poor ground conditions on a separate line. This reduces the chance of reapplying to strips that have already received fertilizer when machinery comes back. The records are also useful for understanding why two parts of a field developed differently, especially when sowing dates or the times of spring treatment diverged.
Use the next walk to check the original diagnosis
Take the second set of photographs from the same height in similar light. Look first at new central leaves and the start of stem extension, then check the gaps. Bright sunlight alone can change the colour of a canopy photograph. Examine plants close up before crediting a fertilizer with the difference.
If the same hollow has caused problems for several crops, bring the previous years of drainage and traffic records to the next discussion. They help identify a recurring rooting problem that a nutrient plan alone will not resolve.
Ammonium sulfate for a plan that calls for nitrogen and sulfur
The product directions list rapeseed in a field-crop group. Consider ammonium sulfate if the field plan calls for both nutrients it supplies. That crop-group row does not establish a first spring amount for an individual overwintered stand. Check the nitrogen and sulfur already credited in other products and confirm the intended application with the farm agronomist.
Ammonium sulfate granulated, 25 kg
Packaging: 25 kg bag (±1%). Contact the sales department for pricing and ordering details.
Confirm the exact bag, required mass and delivery with DÜNGER sales. My Garden can save separate small garden zones and their shopping plans. Keep the commercial oilseed rape calculation on the farm worksheet.
Questions about feeding winter oilseed rape
Check the crown and growing point on several whole plants. Watch for a new leaf from the centre after growth resumes. The outside leaves on their own do not show how much of the plant survived.
Pale young leaves justify a closer look. Compare soil type, moisture, roots and application records in the affected area. Seek advice about analysis if the cause is still uncertain.
The crop for seed needs to develop through flowering and seed fill. A cover crop is managed for its own role and termination point in the rotation. Use recommendations for the purpose you are growing the crop for.
Check rosette survival, stage and how firm the field access is. Inspect areas with different development separately before adjusting the fertilizer order.