Thuja roots have to move from a small nursery ball into a much larger volume of garden soil. Prepare that transition before deciding whether to buy a bag of planting mix. A site with moisture and air around the roots is useful. A hole that stays full of water or a dry root ball surrounded by damp earth hurts establishment even when the ingredients listed on the bag look right. Start with the ground you have, check how water moves and keep the trunk base at the finished grade.

Assess the ground along the entire row

Look at the planting strip after ordinary rain and during a thaw. Mark where water enters, pools and drains away. A slight slope, a buried edge or a row of pavers can change the conditions from one tree to the next. Probe a few spots below loose surface mulch. Compare the garden near the first tree with the lowest corner and any patch where building equipment once stood. Compaction can be local, and the tree on one part of a straight line may be in very different soil from the tree at the other end.

Gently squeeze a little moist soil. Does it form a sticky mass, break into crumbs, or fall loose? Texture is a clue. Strongly clayey soil can be workable where water leaves and the surface has structure, while a sandy site can stay wet if fed by a downpipe. If the soil is too wet to handle without kneading it into a lump, come back when it is workable. See how to assess garden soil before buying fertilizer if you need to compare structure and moisture across several beds.

Check where runoff from the roof and neighbouring surfaces will go in winter or spring. In a Ukrainian garden, a path that looks dry after summer showers may have a drift beside it that thaws slowly. Test the proposed root zone after a wet period whenever you can. Depending on the site, there may be room to move the line a short distance uphill or plant on an appropriately designed raised strip. A wet hollow with nowhere for water to run is a reason to reconsider the placement before planting.

American arborvitae (Thuja occidentalis) can grow in near-neutral and limestone-derived soils. Before paying for an acidic planting mix, check the species and cultivar, then test the garden soil if acidity is a concern. Read any result in relation to actual drainage and texture. A single bag of contrasting soil around the ball gives you little control over the future root zone.

Make the soil transition broad and gradual

A light organic potting medium behaves differently from dense garden soil. A pocket of soft material inside a hard-sided hole can stay wet when the surrounding soil drains slowly, or it can dry differently from the ground around it. Prepare a broad space for roots to grow out into the site. Where ordinary site soil is suitable, use it to refill around the ball. If a bed needs work, assess the soil over the whole intended root area before deciding how to improve it. A sharp change only at the walls of the hole can defeat the purpose of filling it with loose material.

A layer of stone under the ball is not a route for water to leave a low site. Check where water can actually go. If it regularly collects in the root zone despite a usable surface slope, ask a local professional to assess the drainage or choose another place. For a mixed planting, the wider guide to soil conditions for conifers can help you compare trees with different moisture needs. For thuja, take notes on the individual root ball as well as the finished bed.

Find the root flare before you set the height

Lift the tree by its root ball, remove the pot and look where the trunk begins to widen into woody roots. Sometimes there is loose nursery mix above this point. Remove the loose material gently until you can find the upper roots. Check for roots circling the outside of a container ball. You can loosen roots that can be redirected outward without forcing the whole ball apart. Ask the supplier for advice about a densely bound tree before planting it, especially if thick roots cross or press against the trunk.

Set the tree so the root flare sits at the finished grade, visible after the soil settles and the surface is covered. The hole needs enough width for the roots, while the base should hold the ball steady at the chosen height. Firm loose soil gently around the sides and water to settle it. If the trunk leans or the tree drops too low, adjust it while the ball is still accessible. A mound of mulch around the bark makes checking the depth harder. Leave a clear space at the trunk and spread mulch over the soil around it where needed.

Check moisture on both sides of the old pot edge

The original root ball and surrounding ground may take up water at different speeds. Water slowly over the ball and the close soil, then check that water has reached below the surface. Use your fingers or a small hand tool at the edge and compare the root ball with the soil just beyond it. Avoid digging repeatedly in the same patch of new roots. Plan the next watering from the moisture you find, the weather and how long the tree has been planted.

If you find a dry potting mix inside a moist bed, water slowly over the original ball and then recheck. If both samples are wet and water has been standing, stop adding water and look for the cause. A dry, dusty top layer is a poor guide after a shower. If mulch has blown aside or been piled against the stem, correct its position while you can see the surface clearly. New growth tells you something about establishment over time, but a dry spell or an occupied yard can change conditions between visits.

Put the observations into one short planting plan

  • Record the wet, compacted and fast-drying parts of the strip separately when conditions differ.
  • Decide where runoff can leave and whether you can reach each tree for slow watering.
  • Set the finished ground level in the sketch, check the root flare on every tree and leave space for roots to spread.
  • Compare original ball moisture with adjoining soil after planting and before adjusting watering.

Suppose the first of three planting places receives water from a path and has dense soil from recent construction. The second and third spots have the same texture but no signs of lasting water. You could alter the first position or correct the runoff and confirm the improvement before committing to the whole line. There is no need to treat every spot with the same bought mix. Write down the difference while the spots are empty, then use those notes after watering the new trees.

Check the site before choosing a feeding method

Plan for drainage, planting depth and establishment before considering fertilizer. When the soil and tree condition indicate a separate feeding need, compare your situation with the DÜNGER conifer directions. Match the application section to the growth stage, age and size. Surface-applied granules belong on suitably moist soil according to that product's directions.

Complex fertilizer for coniferous evergreens, granules

Complex fertilizer for coniferous evergreens, granules

Keep the number of thujas in My Garden. Keep each measured height in your own notes when using the height-based instructions. Note the wet spots and the edges of the original root balls on your site plan.

Questions about soil for thuja

Assess the finished site and drainage. A workable site can have substantial clay. A root zone that remains saturated or compacted needs attention before you plant.